Our Products
Curing Tank
Specification
The tank has been designed to accommodate 150mm / 70.6mm cube mould and fully insulated, complete with a hinged lid, heater, thermostat and re-circulated pump. Provision of two removable racks allowing free circulation of water around each mould. The pump, drain valves and electrical equipment are housed in a compartment located at one end of the tank. The Tank is heated by a immersion heater under normal conditions and refrigeration system for grey cement the temperature is controlled at 35°C or 100°C ± 2°C / 27°C +2°C, expect for the 15 minutes after immersion of the freshly made specimens.
- 24 Hour cycle from time of mixing.
- Controlled 35°C or 100°C ± 2°C Curing Temperature for concrete.
- Controlled 27°C ± 2°C Curing Temperature for grey cement.
-
Asphalt/ Bitumen Equipment's
-
Concrete TestingBlaine Air Permeability Cementometer Chlorimeter Compaction Factor Apparatus Compression Testing Machine Concrete Permeability Apparatus Cube Mould Curing Tank Direct Shear Flexural Strength Testing Machine Flow Table High Performance Ultrasonic Pulse Velocity Laboratory Pan Mixer Longitudinal Compressometer Mortar Mixer Mortar Penetrometer Pocket Ultrasonic Tester Rebound Hammer Tile Abrasion
-
Soil TestingAggrameter Aggregate Crushing Value Apparatus Aggregate Impact Value Test Aquaprobe Benkelman Beam Apparatus Buoyancy Balance California Bearing Ratio Apparatus Cone Penetrometer Digital Los Angeles Abrasion Testing Machine Direct Shear (Variable Speed) Le-Chatlier Mould Liquid Limit Pavement Dynamic Cone Penetrometer Plastic Limit Sand Equivalent Value Apparatus Sand Pouring Cylinder Shrinkage Limit Sieves
-
Surveying